Learning about your new wall fountain made simple

Make Some Connections

• Connect the bottom end of the silicone water tube (located on back of unit) to the water pump unit.
• Connect the LED Light Power Wire (located on back of fountain), to the female end of the wire connector (attached to water pump). Tighten the wire connector to ensure a water tight seal.
• Place the water pump in the bottom of the water reservoir. Feed the male end side of the water pump power wire through the hole located on the side of the unit.
• Connect to the AC adapter and tighten the wire connector to ensure a water tight seal.

DON’T FORGET…. A water tight seal is imperative in preventing leaks and splashing which can cause potential damage to wood floors, drywall, etc.

Fill'er Up

• Fill the water reservoir with the appropriate amount of water based on your fountain model. *reference your fountain water level guide. Extremely low water levels can cause damage to the pump
• Hang your fountain on the wall and plug into power unit. *see hanging instructions below

BUT FIRST….DO NOT place fountain above a wall outlet or power source as it can create a potential fire risk. Also, when mounting your fountain outside, the provided kit may not work on all surfaces. A sturdy hook, screw or nail should work if it can support 10lbs.

Hang Time

• Locate the ideal location for your fountain using a stud finder to see if there’s an existing stud to drill the provided screw into; if there’s no stud, use the provided plastic sheetrock anchor to place provided screw into.
• Place screw into the wall leaving 50% exposed to hang the fountain from.
• Hang the top inner lip located on the back of the fountain onto the screw. Use a level to ensure the unit is properly aligned to provide the best possible water flow.
• Plug in your unit to power on and enjoy!

A Few More Things

• The water pump arrives pre-set to a standard indoor setting. You can adjust to several water flow speed settings.
• You should check your water basin daily to ensure water is covering the pump and that the water is at the recommended level.
• Hang the top inner lip located on the back of the fountain onto the screw. Use a level to ensure the unit is properly aligned to provide the best possible water flow.
• Plug in your unit to power on and enjoy!